XTC Power Products Rear Light Bar Power Harness wires to the Busbar where it gets Keyed power and ground and includes 3 Light Bar Activation Wires that can reach the center switch mounts in the dash. The other end plugs into the Factory Rear Tail Light Harness to get the Brake Signals, if used with our TSS (Turn Signal System) it will send them to the light bar. This adapter gets the Light Bar Power from the keyed accessory post not the running lights, the Brake Lights from the Plug & Play adapter, this design prevents the running light circuit from overloads, the load is on the 15 AMP keyed accessory system. It comes with a 10 amp in line fuse.
- Easy Install Plug and Play Adapter for Brake Signal
- Power Wire Harness
- Output is Keyed Power, Two Brake Light Wires, Ground and 3 Control Wires
- Includes Cable Ties
- Fits Can-Am Maverick X3 2 seat.
THIS SITE IS PROVIDED ON AN "AS IS" AND "AS AVAILABLE" BASIS. NEITHER WE NOR OUR DEALERS MAKES ANY REPRESENTATIONS OR WARRANTIES OF ANY KIND, EXPRESS OR IMPLIED, AS TO THE OPERATION OF THIS SITE OR THE INFORMATION, CONTENT, MATERIALS, OR PRODUCTS INCLUDED ON THIS SITE. YOU EXPRESSLY AGREE THAT YOUR USE OF THIS SITE IS AT YOUR SOLE RISK. TO THE FULL EXTENT PERMISSIBLE BY APPLICABLE LAW, WE AND OUR DEALERS DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. WE DO NOT WARRANT THAT THIS SITE, ITS SERVERS, OR EMAIL SENT FROM US, OUR DEALERS, OR AFFILIATES FREE OF VIRUSES OR OTHER HARMFUL COMPONENTS. WE, OUR DEALERS, AND AFFILIATES WILL NOT BE LIABLE FOR ANY DAMAGES OF ANY KIND ARISING FROM THE USE OF THIS SITE, INCLUDING, BUT NOT LIMITED TO DIRECT, INDIRECT, INCIDENTAL, PUNITIVE, AND CONSEQUENTIAL DAMAGES. CERTAIN STATE LAWS DO NOT ALLOW LIMITATIONS ON IMPLIED WARRANTIES OR THE EXCLUSION OR LIMITATION OF CERTAIN DAMAGES. IF THESE LAWS APPLY TO YOU, SOME OR ALL OF THE ABOVE DISCLAIMERS, EXCLUSIONS, OR LIMITATIONS MAY NOT APPLY TO YOU, AND YOU MIGHT HAVE ADDITIONAL RIGHTS.