This product is for Racing Competition only and is not legal for use in highway or street vehicles or other non-racing competition off-road vehicles.
Purchasing this product requires you to sign our Vehicle Compliance Waiver here.
The VR Tuned Big Injector ECU Tune for the Polaris RZR xP TURBO will take your RZR even further with horsepower! Upgrading to the larger Siemens 80lb Injectors allows us to get more aggressive with the mapping to achieve almost 8 rear wheel horsepower more than our standard tune. The injectors are very easy to install on the xP Turbo (see link below). With this new tune, you will need to max out your stock wastegate adjustment by turning the wastegate rod almost all the way in. With our big injector tune, we are seeing a gain of nearly 25 rear wheel horsepower on just 91 octane (Note: dyno sheet attached shows Big Injector Tune vs Standard VR Tuned File).
Horsepower Gains (dependent on fuel and modifications)
147 rear wheel horsepower on a Mustang Dyno
28 crank horsepower gain using 91 octane with stock exhaust
30+ crank horsepower 100+ octane with exhaust and recommended parts
Note: To get the maximum performance out of this ECU flash, please tighten your wastegate rod down to limit the travel. The factory wastegate is very soft and weakens over time. The ECU calls for more boost pressure but the wastegate will not allow for this without adjustment.
What are the benefits of VR Tuned?
#1 priority is our customer service to you!
Our tuning is used worldwide.
Basic bolt-on performance parts will not require a retune of your ECU. Other efficiency parts such as colder spark plugs, boost tubes, or diverter valves are not required but can help performance. The ECU will adapt to these changes.
We can tune cars worldwide including JDM, EU, Australian, and USA cars for different types of octane or environments.
We do not lock, "pot", or keep control of your ECU. If you decide to take it to another tuner for an upgrade, all flashing ability is retained.
How to Flash Your ECU?
We can bench flash your ECU. To bench flash the ECU, you must remove it from your vehicle and send it to us (See Instructions Here). You can also send us a new ECU to be flashed. Once we receive the ECU, we will prepare the tune file and then ship it back to you for reinstallation. We do not solder or modify the ECU board at all. All ECU tuning is done via bungy probes that have a needle tip to provide an electrical connection.
Bring your vehicle or ECU to our facility where we can do the ECU Upgrade here.
Order our OBDII Flash cable to be able to flash between a stock and your tuned file. See Instructions Here