The Planted Seat Bracket is a vehicle specific bracket used as an adapter between the floor of the vehicle and an aftermarket seat and it's accessories. Because the floor of each vehicle varies and typically is not flat, a vehicle specific Seat Bracket is required for installing an aftermarket seat. Planted create each seat bracket using the floor of the vehicle as a reference. They literally bring each vehicle into they're development center so they can create the best fitting, bolt in, universal seat bracket possible.
Planted Seat Brackets are laser cut from 3/16 inch thick steel and hand welded to ensure weld penetration for superior strength. Each bracket is pre-slotted with hole patterns to accept sliders from most major seat manufacturers like Braum, Bride, Cipher Auto, Cobra, Corbeau, Momo, NRG, OMP, Racetech, Recaro, Sabelt, Sparco, Status Racing, Takata and more. There is extra space on the bracket for drilling your own hole pattern if using a slider with a less common hole pattern, or direct mounting a seat or side mount when eliminating sliders is preferred. They are finished with a black powder coat and applications are available for many vehicles. Each Planted Seat Bracket goes through three levels of quality control to ensure our high standards are met. All Planted Seat Brackets are hand welded in Bellevue, WA, USA.
3/16" Steel, Black powder coating
Extra material provided to eliminate seat slider
Seat Sliders NOT included
UNIVERSAL. STRONG. SECURE
Made in USA
Datsun 280Z with Flat Rear Tabs 74-78
Seats come in many different shapes and sizes so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit prior to ordering the Seat Bracket and other components.
Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size then the factory seat.
Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor but it is up to the end user to determine if a resistor will work & which resistor to use.
The Planted seat bracket is made with 3/16" steel for superior
strength. It is built to accept sliders from most major seat
manufacturers like Bride, Cobra, Corbeau, Momo, OMP, Racetech,
Recaro, Sparco, Status and more. Extra material is provided for
direct seat or side mount applications where eliminating sliders is
preferred. They are finished with a black powder coat and
applications are available for most cars.